Kawasaki Teryx Bikini Top Buckle Straps Installation Instructions
download Thread the front straps through the buckles. Do not tighten yet. Repeat on both sides. Thread Front Straps through Buckles Use a 19mm wrench to remove the existing bolt in the support cage....
View ArticleKawasaki Mule Lift Kit Installation Manual
download Front Lift Installation 1. Ensuring that the parking brake is set, place jack under center of the Mule front end and lift until front wheels clear the ground. Be careful to support Mule...
View ArticleKAWASAKI MULE Electric Steering Installation Manual And Removal
download Remove plastic center cap on steering wheel by prying off with a small screwdriver. Remove steering wheel nut and remove steering wheel by pulling up on wheel. If wheel is tight have a partner...
View ArticleKawasaki Vulcan 500 Receiver Hitch Installation Manual
download 1) Place motorcycle on its side stand on a firm level surface. 2) Remove saddlebags if any. 3) Remove rear riders pegs. 4) Attach front of bracket A (left side) and bracket B (right side)...
View ArticleKAWASAKI TERYX EFI Installation And Removal Instructions
download 1. The Stage IV controller can be mounted in numerous places. Placement depends on personal preferences. Only mount in locations where no damage may occur from sharp or hot objects. 4. Start...
View ArticleKawasaki ZX-9R Ninja TiForce exhaust system Installation Instructions
download 1. Remove the lower fairing. Remove thelower radiator mounting bolts, loosen the upper bolts and pivot the radiator forward to provide access to the exhaust nuts (flange nuts). Remove the oil...
View ArticleKawasaki Voyager 1700 Hitch Removal both saddlebags and Installation...
download Remove the seat. Remove both saddlebags by removing the 3 bolts shown below Remove the plastic liner in the bottom of the trunk by gently pushing in on the center of the plastic clips Once the...
View ArticleKawasaki ZX6R 2009 Frame Slider Installation and removal Instructions
download 1. Remove mid and lower body panels Left and Right. There is a small plastic cover that is mounted over the main engine stud location on the left side. This cover requires a small notch to be...
View Article2002 Kawasaki 360 ATV WINCH ACCESSORY INSTALLATION INSTRUCTIONS
download 1. Remove the two 8mm bolts that attach the front bumper assembly to the ATV frame see figure 3. 2. Place Winch mounting plate (A1) into position and fasten the two bent down tabs to the ATV...
View Article2004 Kawasaki ZX10R Power Commander Installation Instructions
download Remove the main seat and the passenger seat 2. Remove the tail cover by removing the two bolts. 3 Place the Power Commander in the tail section and route the wiring harness on the inside of...
View Article